Video: Aprilaire 4839 Maintenance Kit for Model 600

Aprilaire 4839 Maintenance Kit for Model 600 Product Video and Installation Assembly
Credit Cards Accepted Support Cart
Need Assistance? Live Chat 800-825-2148
 

Video Home » Aprilaire 4839 Maintenance Kit for Model 600


Rate this video
  • 4.0/5 (2 votes)
Plays:
Length: 4:40
embed

Hi, I'm Jay, and this is the Aprilaire 4839 Maintenance kit. It should be replaced every 5 years. Included in the kit is a water panel, scale control insert, water distribution tray, feed tube kit, strainer screen, and drain spud. 

 

Replacement is easy, here's how. Be sure to turn the power off, before performing any maintenance. Before performing this service, it is necessary to shut off the water. Find the saddle valve, turn it clockwise, until it stops. 

 

You'll notice on the top of the water panel, there is a spray mark. That indicates the top. We're going to slide it into the scale control insert. Take the distribution tray, snap it into place. This side here with the little loop goes towards the inside of the humidifier. This side goes towards the furnace or duct work. This assembly is now ready for installation inside your AprilAire humidifier. 

 

Grab the end of the feed tube with the orifice in it. Slide the brass nut on first. Followed by the nylon ferrule. Be sure to have the ferrule with the skinny side pointing towards the end. Now it's ready for assembly onto the solenoid valve. The feed tube material is rather stiff. On some models, it may be necessary to warm it up with a hair dryer in order to bend it. Be careful not to overheat it. 

 

We're going to use a 1/2 inch wrench to disconnect the feed tube. Now let's connect the feed tube to the solenoid valve. Insert the feed tube into the solenoid valve, until it bottoms out. Slide the ferrule and the brass nut forward, and hand tighten it. It's important at this point to keep pressure on the feed tube so it does not back out of the solenoid valve when you tighten it. Now we're going to tighten that up. So now we're going to change the strainer screen. This is the incoming water line, the solenoid valve, and the feed tube. There's an arrow here indicating which direction the water flows through the solenoid valve. Here's the tools we'll need. 7/16 inch wrench, 1/2 inch wrench, pair of needlenose pliers, and a common paper clip. Now, we're going to disconnect the water line. We'll loosen this up, pull the water line out of the way. Now we're going to take the paper clip, and straighten that out. Alright, that's straight enough. Now we're going to bend a small hook on one end of it. There we are. The small hook is going to be used to catch the strainer screen. We're going to slide it in like this to grab the old one. So, we're going to reach into the valve, grab the old strainer screen, pull it out, and dispose of it. Now we're going to take the new strainer screen, insert it into the solenoid valve, take the straight end of the paper clip, and use that to push the strainer screen into place. Now all we have to do, is reconnect the water line. Tighten it up, and there we have it. It's all done. Now the only thing you need to do is turn the water back on. Now we'll attach the feed tube. It's a friction fit. 

 

Thank you for watching, for this and other this and other products, visit us at AirQualityParts.com




» Be first to receive the latest updates!
Add to My Yahoo!My GoogleMy AOL
BloglinesNewsgatorNetvibes.



Copyright | On Time Mall Inc. | All Rights Reserved | 800-825-2148